Peter Paul Solenoid Valve Model EH21

MAX. OPER. PRESS. DIFF. LIQUID AC/DCORIFICE SIZECV FACTORVALVE NUMBER CONDUIT HOUSING LIQUID 1/8 NPT30001/32.024EH21G7DCCM-∆15003/64.052EH21H7DCCML-∆8501/16.095EH21J7DCCML-∆3003/32.156EH21K7DCCML-∆ MAX. OPER. PRESS. DIFF. GAS AC/DCORIFICE SIZECV FACTORVALVE NUMBER CONDUIT HOUSING GAS 1/8 NPT30001/32.024EH21G7DCCM-∆25003/64.052EH21H7DCCMG-∆13501/16.095EH21J7DCCMG-∆4503/32.156EH21K7DCCMG-∆* FKM seals not recommended for pressure ratings above 500 PSISeal Material: Replace ∆ with desired code – Blank = Nitrile (Buna) S = Low Temp Buna. N = FKM* E = Neoprene A = EPDMOrdering Information:When ordering valves or repair packs add voltage and frequency to complete valve number. for examples: valve (EH21JDDCCMG 120/60) repair pack (2KEH21J AC) Operating Conditions:Media: Air and other non-corrosive gasses, water and oil.Filtration: Down to 60 microns or less is recommended.Valve Temperature Range:Standard Valves – 0°F (-18°C) to 104°F (40°C) ambient; 0°F (-18°C) to 150°F (65°C) media.Optional Valves – can tolerate much higher or much lower ambient and media temperatures.*Maximum Operating Pressure Differentials: See table above.Burst Pressure: 10,000 PSILeakage: Bubble tight for standard valves. Electrical Characteristics:Coil Voltage: 12/DC, 24/DC, 48/DC, 125/DC, 120/60-110/50, 240/60, and 24/60.Nominal Power: AC — 7.3 Watts DC — 9.5 WattsCoil Construction: Molded Class F with third wire ground (Std.), Class H or Potted (Opt.)Typical Response Time on Air: 4 – 16 MillisecondsOperating Speed: Up to 600 CPM with gas mediaDuty Cycle:  Continuous Mechanical CharacteristicsBody: 300 Series Stainless SteelInternal Components: Stainless Steel. Copper – AC Only.Elastomers: Nitrile (Buna) (Std.). Many other elastomers available.*Sealing Pin: Kel-F (Std.), Delrin®, Teflon®, Nylon, PEEK, Radel®, Ultem®, 303 Stainless Steel (Opt.)Orifice Diameter: See table above.Porting: 1/8″ NPT.Housing: Flame-Proof construction with 1/2″ NPT conduitListings: Valves are UL listed for use in the United States and Canada for Hazardous Locations — Class I, Div 1, Group C and D – Class II, Div 1, Group E, F, and G; Div 2, Groups A, B, C, D, E, F, and G.Life Expectancy: Millions of cycles, depending on application, lubrication, etc.Valve Weight: 2.38 lbsRepair Packs: See table above.Options: Alternate Sealing Pin Materials and Alternate Elastomers*